6ATCFFAA
Wiremold®* Actual product may vary from image
For carpet, tile, wood and laminate concrete floor coverings. For use in 6" (152mm) diameter opening. Devices are recessed 3 1/4" (83mm) below floor surface. Die-cast aluminum cover assembly provides one (1) 3/4" trade size screw plug opening and one (1) concentric 2"-1 1/4" trade size screw plug opening and is available in the following powder coated finishes: (BK) black, (GY) gray, (NK) nickel, (BS) brass, and (BZ) bronze. INCLUDED: For Side Compartments: No Device Plates are provided. For Center Compartment: No Device Plates are provided. For Bottom Feed Compartment: One (1) 5PTHA 1/2-Gang Pass-Through Housing Assembly, One (1) 5FFHA 1 1/2-Gang Pass-Through Housing Assembly, One (1) 575CHA 1/2-Gang 3/4" Conduit Housing Assembly (also includes junction box attached to the 3/4" conduit). NOTE: UL Fire Classified for up to 2-hour rated floors. Bruched Aluminum
Details
MFG PART #:6ATCFFAA
TRC Part #:WMLD6ATCFFAA
UPC #:786564096337
Inventory
$947.99 E
Details
MFG PART #:6ATCFFAA
TRC Part #:WMLD6ATCFFAA
UPC #:786564096337
Inventory
Attributes
Features
Documentation
Attributes
Brand:Wiremold®
Type:Fire Classified Furniture Feed
Series:Evolution™ Series
Hole Size:6 in
Number of Gangs:3
Capacity:2578.88 cu-in
Length:16-1/4 in
Width:7-3/4 in
Suitable For Use With:Carpet, Tile, Wood, Polished Concrete and Terrazzo Floorings
Cover Material:Die Cast Aluminum
Material:Aluminum/Plastic/Steel
Finish:Brushed Aluminum
Features
| 3-Compartments for power, communications and/or A/V devices, all recessed 4 in below the floor level, providing maximum protection and device longevity |
| Compatible with most A/V manufacturers devices including their 1-gang decorator style design |
| Flush style cover for tile applications allows the Evolution™ series poke-through devices to be adjusted to the same level as the top surface of the floor covering |
| Tile cover is designed to be used in higher traffic applications, where a low profile is a must |
| Egress doors lock in position when slid open and automatically close around cables, reducing the egress opening to the smallest size possible |
| Step-on-it installation - quick, easy installation without the need for additional fasteners or a second installer |
| Creates a cast in place core hole that allows the contractor to position poke-through units before concrete is poured |
| Eliminates the cost and labor of coring the opening |
| TopGuard™ protection - all Evolution™ series poke-through devices, like every Wiremold® poke-through device, meet and exceed UL scrub water exclusion requirements for tile, carpet and wood covered floors |
| Poke-through trim flanges are beveled so the slope is no greater than 1:2 ratio |